I've recently got back into revolvers again after a long hiatus, which had led me to be more on the lookout lately when looking at my local stores and on Armslist
Was looking through Armslist I saw a posting for a S&W 640-1, the pictures weren't the greatest but the guy was willing to trade (which is a must for me cause I'm expecting my first kid so funds are tight). We exchanged emails back and forth, finally arranging a deal for a Glock 43 I had gotten on trade for the 640-1
I had looked up the price ranges in my area, they were selling around $450-600 in good condition. Worked out a straight trade with the gentleman and meet up earlier today
Once we met up, I got to looking over the revolver while he did the same with the Glock 43. The gentleman I got it from hadn't cleaned it in some time, had owned it for the past 5 years, and had the worse grips (at least in my humble opinion possible) Barami hip grips which I immediately took off to check the frame. They hadn't been off in some time for cleaning, so some surface rust and pitting had started around the edges. Also the left side of the trigger has bad putting on it
Normally once a deal is struck with someone, I stick to it unless something comes up but this was in alot rougher shape than was advertised and from pictures he had sent me before we met. We struck up a conversation, renegotiated the deal to were I was comfortable doing it and to compensate for the miscommunication.
I got it home and started cleaning it up. Trigger is very nice, I really enjoy the weight of the revolver. Got to thinking about it, made a call to my local gunsmith and asked about bead blasting it. To completely clean up the revolver, bead blast it, and install new spring will run me about $150. Just have to make up my mind about whether I want to go that route
It's pictured without the grips cause I didn't want to put them back on cause I disliked the Baramis so much. Do have a set of Altaman boot grips ordered for it
Was looking through Armslist I saw a posting for a S&W 640-1, the pictures weren't the greatest but the guy was willing to trade (which is a must for me cause I'm expecting my first kid so funds are tight). We exchanged emails back and forth, finally arranging a deal for a Glock 43 I had gotten on trade for the 640-1
I had looked up the price ranges in my area, they were selling around $450-600 in good condition. Worked out a straight trade with the gentleman and meet up earlier today
Once we met up, I got to looking over the revolver while he did the same with the Glock 43. The gentleman I got it from hadn't cleaned it in some time, had owned it for the past 5 years, and had the worse grips (at least in my humble opinion possible) Barami hip grips which I immediately took off to check the frame. They hadn't been off in some time for cleaning, so some surface rust and pitting had started around the edges. Also the left side of the trigger has bad putting on it
Normally once a deal is struck with someone, I stick to it unless something comes up but this was in alot rougher shape than was advertised and from pictures he had sent me before we met. We struck up a conversation, renegotiated the deal to were I was comfortable doing it and to compensate for the miscommunication.
I got it home and started cleaning it up. Trigger is very nice, I really enjoy the weight of the revolver. Got to thinking about it, made a call to my local gunsmith and asked about bead blasting it. To completely clean up the revolver, bead blast it, and install new spring will run me about $150. Just have to make up my mind about whether I want to go that route
It's pictured without the grips cause I didn't want to put them back on cause I disliked the Baramis so much. Do have a set of Altaman boot grips ordered for it
