Smith And Wesson Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Recently picked up a used Model 617 .22lr with four inch barrel. Shoots fairly well at 25 yards, however printing about 2" high with three different ammo types and the rear sight is adjusted down as low as it'll go.

Called S&W today and the only help was to send it in and wait 3-6 months or visit a local gunsmith.

Although I hate to do it, optimal accuracy is important so thinking I may have to find a "not so ugly" way to slightly build up the front sight. Thinking a drop of JB Weld?

Wonder if anyone has experience with this and could share what they did?

Thanks
 
1 - 2 of 2 Posts
Top