Smith And Wesson Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have the California Shield 9 mm in which the pin is out that holds the sear deactivation lever, magazine safety lever, and magazine safety spring. I have spent 3 days trying to reassemble the sear housing block with these parts. I cannot figure how the magazine safety lever and magazine safety spring can be successfully loaded into the block. Has anyone come up with a tip or trick for aligning the spring in the safety lever correctly? I don't want to send the entire Shield back to S&W. If I cannot insert the spring myself, is anyone out there aware of someone who could insert these items back into the sear housing block?
490945
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top