Smith And Wesson Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi, New guy to forum here.

Recently purchased a PC 12" Hunter. I have taken note to the fact the the barrel fitting reminds me of the Dan Wesson, where the barrel is screwed down to acheive the .003 cylinder gap and the barrel nut then locks it all in place.
Has any one tried to adjust the tension of the barrel nut in an attempt to tune the barrel to a specific round like the DW?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.