Smith And Wesson Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1 (Edited)
Hi,
I have an older Mod 60 .38 Spl that I am changing the hammer on. I watched a video on you tube showing the taking down and reassembly of the model, and it showed removing the hammer spring by decompressing the spring with your fingers and removing the spring , end cap, and rod. This was done without problem. I looked and found a video showing the decompression with the hammer before removing and inserting the paper clip or small drill bit into the hole in the rod to keep the spring compressed for reassembly. Any suggestions on compressing and getting the spring back onto the rod and the end cap back on in the frame?
Thanks,
Robert
 
1 - 1 of 1 Posts
Top