Smith And Wesson Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
Hi, new member here!

I have a Model 41 ('80s model, I think) with a 5.5 inch slide, but the rear sight is missing its elevation screw.

I've been keeping an eye on Numrich for the past little while (pre-covid-19), but no luck with either the elevation screw, or complete rear sight assemblies.

Are there any other good sources for this part or a complete assembly that I should be keeping my eyes on, or am I out of luck?

I'm in Canada as well, which might make sourcing parts a bit more difficult.

If I can't find this part, I'd be open to mounting another dovetail-compatible rear sight, or perhaps a red dot of some sort -- anything that will make this slide useable :)

Thanks!
468329

468331
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
Thanks! I'll have to keep an eye out there then. I do see a sight assembly there right now, but it's also missing the elevation screw :D.
 
1 - 5 of 5 Posts
Top