Smith And Wesson Forums banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
162 Posts
Discussion Starter #1
I finally received the feeler gauge from S&W to check the bolt on my 15-22. For any that didn't know, they have a safety alert to have the bolt checked on the 15-22 rifles for the proper cut away depth. I found out from the fine folks on this site. Mine checks out ok.

I drew the gauge in the event that anyone wants to make their own or use a similar feeler gauge, or use a depth gauge to check the bolt. The cut away on the bolt should be deeper than the gauge is thick, or flush. Or if measuring no less than 0.88mm (0.035"). Also the link to the S&W info is below.


https://www.smith-wesson.com/mp15-22-consumer-safety-alert


M&P go-nogo.jpg


bolt examination.jpg
 

·
Premium Member
Joined
·
162 Posts
Discussion Starter #3
Yes, a simple check, only takes a few minutes.

I will say that it took S&W about three weeks to ship mine. I emailed twice before it showed shipped.
 
1 - 3 of 3 Posts
Top