Smith And Wesson Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
How do you remove stock grips? What replacements are currently available?I am looking for a checkered grip,mine are like the ones on Shooboys in previous post on diassembly.Do any other S&W grips fit?I know about Pachmayers and have bid on some on ebay.
 

·
Registered
Joined
·
44 Posts
1. Make sure gun in unloaded and hammer is fully forward (if not, the hammer spring will have extra tension on the backstrap when you try to remove it)
2. Push pin out at the bottom rear of the magwell
3. Pull the bottom of the backstrap out/backwards
4. The grip panels then pop off the sides

Sorry, no idea about where or what is available for replacements.

(Editted to add step 1)
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top