Smith And Wesson Forums banner
1 - 10 of 10 Posts

·
Registered
Joined
·
3,421 Posts
Discussion Starter · #1 ·
Well, I got my cylinder and ejector rod housing back from Bowen Arms. They did a blackpowder chamfer because there were a couple of dings on the edges of two of the flutes, long gone now.

 

·
Super Moderator
Joined
·
8,997 Posts
Looking good!! What's a job like that cost?
 

·
Registered
Joined
·
276 Posts
I think it's great looking too, I also like the BP bevels, as well as looking nice they make reholstering easier on your leather. Frank
 

·
Registered
Joined
·
2,004 Posts
Gazing upon that beauty, all I can think is, "Skeeter sure was right!"
 

·
Registered
Joined
·
3,421 Posts
Discussion Starter · #7 ·
If I recall, BP Chamfering the cylinder was only about $75.
 

·
Registered
Joined
·
626 Posts
That looks good, congrats.
 
1 - 10 of 10 Posts
Top