Smith And Wesson Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
8,734 Posts
Discussion Starter · #1 ·
trying to come up with a load for a guy's 7MM mag and all he had was Federal brass. After trimming the 20 pieces, I found that there is a 10gr. difference in the brass {high/low} and no two pieces are the same. I have always used Winchester or Remington brass in my rifles and have never had this much variance in brass weight. What are the experiences of others?
 

· Registered
Joined
·
8,734 Posts
Discussion Starter · #5 ·
Thanks guys, ended up going with Winchester brass. I think I may be on to a good load too
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top