Smith And Wesson Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Seem to recall a member named Paul105 that indicated he developed a deep seated load. I've been offline for years but I'm back into refining a load for my three 329pd's. In my estimation, Paul was the authority on these. So Paul, if your still on the forum or if someone has info on this I'd appreciate a response. Bill
 

·
Registered
Joined
·
2,602 Posts
I'm not Paul but I have deep seated plenty of 44 and 357 mags . Usually while looking for a milder load for 44 mag or 357 while still using full length brass so as to avoid the crud ring.
Only done it with cast bullets and deep seated past the crimp ring to the front of the driving band. Then roll crimped trying to get a little traction on the front corner.
That leaves about The same internal capacity as a 44 spl. ( or 38 spl. if dealing with 357) so 44spl reloading data was a great place to start. From there work up to whatever YOUR gun likes.
 
  • Like
Reactions: lawdog and jeepnut
1 - 2 of 2 Posts
Top