Smith And Wesson Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
753 Posts
It's something that can be done home easily. The blade height is .150 tall or something close. Try Brownells if they carry one for the 617.
Place the new sight blade on the gun, then you can drill from both ends so you don't damage the revolver itself.
The sight will need to be drilled using a #54 Drill. Use the same drill bit to press out the pin, if you don't have a cupped punch (radiused tip so you don't flatten the pin end).
When done drilling put a drop of thread loctite on the pin and push it in.
 

·
Registered
Joined
·
753 Posts
Free hand. Go half way from one side then drill it on the other until it breaks thru. This way there is no chance of hurting the gun.
I've done many and it's really easy to to. Just take your time.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top