Smith And Wesson Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
266 Posts
Don't do this at home kiddies but I hand load .38 S&W with perfectly fine results by using my .38 Special sizing die and then 9mm dies for, case mouth flaring, bullet seating, and for the crimping operation. No muss, no fuss and the cases don't split, swell, or threaten to turn into rabid, yellow dog democrats. I'm sure that the 4 boxes of brass I've been using for the past 10 years have at least 5 loadings on them. I got 1000 .38 S&W cases from CXM but haven't had to dip into them to this point.

I shoot the hand loads in a Colt Banker's Special and a Webley Mark IV.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top