Smith And Wesson Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I have a 32-20 Hand Ejector 3rd change (K Frame) that had a timing issue. The hand was slightly worn and under timing it slightly. Well an old gunsmith buddy suggested I could ever so slightly peen the end of the hand to lengthen it just a bit and it should fix the problem. I did it and tested and it was definitely helping. Problem is I decided it needed to go a hair longer and the tip of the hand broke off. Now I'm in search of a replacement and not having any luck. Numerich's doesn't have anything for them besides a barrel and cylinder.

Are there any other models that should be interchangeable? Any other options?

Thank you!
 

·
Registered
Joined
·
5 Posts
Discussion Starter #2
Here is a picture of one that I ordered from Numerich's but found that it was for an I-Frame and too small. It looks identical to the one I need, just too small.
I-Frame Hand 1 Pin.jpg
 

·
Premium Member
Joined
·
18,605 Posts
welcome01 to the forums from the Wiregrass! This one should work. Sometimes you have to dig a little at Numrich.
 
1 - 8 of 8 Posts
Top