Smith And Wesson Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Has anyone had the issue of not being able to get the barrel off of the 22A? I have the slide locked back and the release button just doesn't budge. Any help would be much appreciated.
 

·
Registered
Joined
·
114 Posts
Use a Rubber or plastic mallet to push the button in (gently hitting the button). It will loosen up a couple times. I have not had this problem when I owned mine but have read about it on RFC.
Good Luck.
 

·
Registered
Joined
·
1,058 Posts
I have had similar situation. Find the edge of a kitchen counter, or picnic table or work bench that has a sharp 90 degree angle. Place the bottom of the barrel along the top of the counter while placing the break- away button snug against the down edge. Then just lean in with your weight against the button. It should pop the button to depress it. Good luck.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top