Smith And Wesson Forums banner

barrel

  1. WTS M&P Shield 9mm Barrel

    WTS, WTB, WTT-OTHER ITEMS
    SOLD M&P Shield 9mm Barrel ** SOLD ** Bought this off eBay about three years ago and never used it. $50 shipped.
  2. SW22 Barrel nose on Receiver not squared

    Smith & Wesson Rimfire Guns
    Every SW22 I've seen has the same issue. The "nose" on the end of the receiver is not squared. On my gun it's shifted to the left a few thousands, of an inch, and off in the horizontal the same. At least mine is square in the vertical. I have seen others that are not squared in any axis. The...
  3. WTB Dan Wesson 4 inch barrel and shroud

    WTS, WTB, WTT-FIREARMS ONLY! Please Read Rules!
    I am looking for a nice 4 inch Dan Wesson barrel and shroud. That is all I need to have a complete set except for the belt buckle. If you have one, plese contact me. Any leads would be appreciated. Doug
  4. S&W Model 10 Barrel Cut Down?

    S&W Revolvers 1945 to Present
    I have acquired a S&W Model 10 that i believe was a british air force side arm. Just looking for some more information based on the expertise of you guys on this site. I was informed that it appears the barrel has been cut down, since the ejector rod looks to be that of a 5 1/2 inch barrel and...
  5. PC 12" hunter barrel nut question

    S&W - Gunsmithing
    Hi, New guy to forum here. Recently purchased a PC 12" Hunter. I have taken note to the fact the the barrel fitting reminds me of the Dan Wesson, where the barrel is screwed down to acheive the .003 cylinder gap and the barrel nut then locks it all in place. Has any one tried to adjust the...
Top