+ Reply to Thread
Results 1 to 4 of 4
  1. #1
    Senior Member
    Member #
    134
    Join Date
    Jan 2009
    Posts
    553
    Liked
    133 times

    prewar/postwar transitional 32 snubby

    man, i rooted out a scarce one today! as you all probably know by now, early snubs are by far my favorite smiths. kinda at the last minute, i decided to go to a gunshow that i had never attended before, and the first row in, i spotted a 32 snub with early features, in unbelieveable condition. i instantly paid the asking price, and came happily home! i was assuming late 40s era (4-line address), but the serial number is firmly in the prewar era. it has all the prewar features: "32 s&w long ctg" on the left side of barrel, with no other barrel markings, leaf main spring, all 6 screws (4 sideplate, triggerguard, and strain), serial marked service stocks, all numbers match (barrel,cyl, frame, grips), half-moon sight, and no rework markings.
    man, it is beautiful! i can't believe a gun could survive for the length of time it has, and remain in such nice condition. i honestly doubt if it has been fired. there is a very faint turn-line, a very light scratch near the cyl release latch, and a little light rub on the lower edge of the frame below the cylinder latch. the grips and recoil shield area are pristine. it is spotless under the grips, and the bore/bores are virginal looking! every screw looks untouched.
    man, i am excited! i apologize for being goofy, but i have looked for one of these for a long time!


    am i correct in assuming that there were absolutely NO prewar snubs with the 4-line address? i realize that the 2 inchers were few and far between, and have a lot of strange combinations of features. i guess some prewar serial numbered frames sat around during the war, then were assembled at later dates.

  2. #2
    willie
    Guest
    Don't know much about it, but it is a beauty!

    Willie

  3. #3
    Senior Member
    Member #
    2281
    Join Date
    Jul 2010
    Location
    Arizona
    Posts
    3,511
    Liked
    1220 times

    Wink

    Sweet! You can usually tell if a revolver has been fired by taking a close look @ the front of the cylinder, look for 'burn' rings around the ends of the chambers. I've noticed some that had every other chamber fired that I presume are factory test firing. I managed to 'cure' all of the unfired ones I have.

  4. #4
    Senior Member
    Member #
    41
    Join Date
    Jan 2009
    Location
    Sebago Lake, Maine
    Posts
    6,487
    Liked
    35 times
    Man, that's super nice....

    Based upon the features, here's one that I assume is from the same era...







    Does your have the hammer block?

    Four Line Addresses are from the post war era...

    Drew
    ".... Evil Flourishes When Good Men Do Nothing...."


 

Sponsors

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Similar Threads

  1. 1946 38/44 OD Transitional
    By DHENRY in forum S&W Revolvers 1945 to Present
    Replies: 5
    Last Post: 03-22-2010, 09:55 PM
  2. Another early postwar K-22
    By DCW in forum S&W Revolvers 1945 to Present
    Replies: 20
    Last Post: 02-15-2010, 10:12 PM
  3. 38 M&P (Postwar)
    By Gizamo in forum S&W Revolvers 1857 to 1945
    Replies: 3
    Last Post: 09-05-2009, 09:57 AM
  4. PRE WAR & TRANSITIONAL KIT GUNS
    By hendricks in forum S&W Revolvers 1857 to 1945
    Replies: 13
    Last Post: 06-11-2009, 08:02 PM
  5. 1946 transitional O.D.
    By DHENRY in forum S&W Revolvers 1945 to Present
    Replies: 5
    Last Post: 02-12-2009, 08:53 AM

Search tags for this page

.32 s&w snubby
,
32 smith and wesson snubby
,
pre war m&p snub
,
pre war s&w .32 snub revolver
,
prewar features
,

s&w m&p prewar snub revolvers

,
s&w transitional
,
s&w.32snub
,
smith and wesson 32 long ctg serial numbers
,
smith and wesson 32 snub
,
smith+wesson+22 postwar transitional
,
smith+wesson+22+postwar transitional
Powered by vBulletin® Version 4.1.4
Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.
SmithandWessonForums.com is not affiliated with Smith & Wesson. We are an enthusiast site and fans of Smith & Wesson Firearms. To visit the official Smith & Wesson site, click here: Smith-Wesson.com.